Dryer Repair Safety and Steps on How to Install an Electric Dryer

Dryer Repair Safety

When repairing an appliance one should be concerned with safety, this is especially true when conducting dryer appliance repair. Here are five short safety tips that will help you repair your dryer safely.

Unplug the Appliance

This may seem like a no brainer, but unplugging the dryer and turning off the circuit breaker should be the first step before doing any electrical repair work.

Reinstall the Wiring Correctly

Always reinstall the wires correctly per any wiring diagrams. Make sure Information about Constipation Relief they aren’t pinched, crossing any sharp areas, caught in a panel or between moving parts. If they are, you risk Tips For Budget Planning: Investments and Savings an electrical malfunction.

Replacing Parts

Always make sure you replace parts using the correct size and/or serial numbers. Using parts that are too big or too small risk further damaging your dryer.

Individual Safety

Above all else, be sure to protect yourself. If lifting heavy objects, ask someone to help you and communicate effectively so as not to drop the appliance and injure someone. Work in a well lit area. Don’t stick your hands in areas that you haven’t inspected, you risk cutting your hand on any protruding sharp objects – edges or screws.

How to Install an Electric Dryer in 9 Steps

• Step 1

Make sure that your outlet and dryer requirements are the same before you purchase your dryer, if possible. Most dryers are 220 volts, but some smaller, older ones still use 110 volts.

• Step 2

Check to make sure the vent hole on the dryer is compatible with the vent hole in your home. If they are not compatible, you will either have to make a new hole or get a different dryer.

• Step 3

Turn off the breaker or breakers feeding the dryer outlet. A 110-volt outlet will have one breaker; a 220-volt outlet will have two.

• Step 4

Be sure What Should Be Your Queries While Talking to the Sacramento Used Car Dealers that the floor is clean and dry.

• Step 5

Fasten the vent hose to the duct leading outside with a hose clamp, a circular metal ring that resembles a tie wrap with a bolt on top.

• Step 6

Plug the dryer in and move it into place, hooking up the vent hose when you can reach it. Use a hose clamp to fasten the hose to the How to Choose the Correct Caterer For Your Perform dryer's exhaust port.

• Step 7

Push the dryer the rest of the way into the space, being careful not to crimp the hose.

• Step 8

Turn the breaker or breakers back on.

• Step 9

Dry!

Tips & Warnings

• Call a licensed electrician to change the outlet if Easy Ab Workouts it's the wrong voltage; a new breaker will have to be installed.

• Use a smooth, flexible metal duct, not a corrugated plastic/vinyl vent hose. It will last much longer and is less likely to kink.

• Leave a couple inches of space on both sides of the unit to allow for circulation.

• Keep the vent hose as short as possible to reduce drying time.

• Put your owner's manual in a plastic bag and tape it to the side of the dryer.

Sammy has this site named: http://www.partstore.com/Content/Pages/dryer-filter.html that contains lots of information regarding dryer filter and dryer part.